Semi-Automatic Setup Mode Without Relief - Selve commeo SE Breeze-com Originalbetriebsanleitung

commeo commissioning/setting by radio
Note for settings under point 5.2.: The drive must be selected for these settings with a
transmitter in SELECT mode (status LED slowly flashes orange). After the setting has been
configured, the drive is still selected (see point 5.).

5.2.2. Semi-automatic setup mode WITHOUT relief

in operation: bottom position, top stop
When the movement is interrupted twice during operation, the system signalises that it is in
semi-automatic setup mode. The drive only finds the upper end position automatically.
Important: A limit stop is required for the upper end position!
The lower end position must be approached first.
Operation
9 s
or
3 s
or
Movement
Press the STOP button on the transmitter for 9 seconds.
Both previously set end positions are deleted.
Note: Can be omitted during the initial installation or
after resetting to the factory settings.
Move the drive to the lower end point using the UP or
DOWN button.
STOP
Deactivation of the relief: Press and hold the STOP but-
ton for 3 seconds. The direction of rotation will be set
correctly after the end positions have been set.
From here, move to the upper stop without interrup-
5 cm
tion. The drive stops automatically.
STOP
This correctly sets the direction of rotation. Perform a
test run. The drive moves upwards against the stop and
is no longer relieved.
50