Automatic Setup- Mode - Selve commeo SEE-com Originalbetriebsanleitung

Setting of the end positions

4.5.1. Automatic setup- mode

in operation bottom position, top stop/release
In delivery state the drive will, after the connection to the operating element, only execute a
moving interruption, which will be done twice at the first moving operation.
For the operation blocking springs/burglar proof fixations and fixed stoppers trailing edges
are mandatory.
Switch off the power supply and connect the drive to the switch or setting switch.
Operation Drive
M 1
~
N
PE
L
1 2 2
PE
L1
N
M 1
~
N
L PE
1 2 3
PE
L1
N
If the running direction of the drive corresponds to 'Up' and
'Down' of the switch or setting switch, initial operation is com-
pleted.
Perform a test run: The drive stops automatically at the end
positions and performs a short release.
3 4
0
L
Otherwise, switch off the power supply and swap the grey
and black connecting wires of the outputs of the switch or
setting switch. Initial operation is completed.
Perform a test run: The drive stops automatically at the
end positions and performs a short release.
2 4
0
L
40