Setting The Wind Sensitivity; Displaying And Changing The Set Wind Sensitivity With A Switch Or Setting Switch; Displaying The Set Wind Sensitivity - Selve commeo SE Breeze-com Originalbetriebsanleitung

Setting the wind sensitivity

6. Setting the wind sensitivity
Note: • The configuration of the end positions must be completed.
• In the delivery state, the wind sensitivity is set to level 2 and is active after the end
positions have been set.
Important: The procedure for displaying or configuring the wind sensitivity using a switch, a
setting switch and a commeo handheld or wall transmitter is identical.The wind sensitivity
can also be displayed or configured very conveniently using the commeo Multi Send.Proce-
dure for the display or setting: First, the lower end position of the awning is approached. The
following setting is configured only with the DOWN button on the switch, setting switch or a
commeo handheld or wall transmitter.

6.1. Displaying and changing the set wind sensitivity with a switch or setting switch

6.1.1. Displaying the set wind sensitivity

Operation
E
1 s
E
1 s
E
3 s
After about 5 seconds, the drive briefly moves upwards once or several times. The number of
brief upward movements results in the set wind sensitivity. The value for the wind sensitivity
can be set to between 1 and 5.
Movement
Move the drive to the lower end position by pressing the DOWN but-
ton.The drive switches off automatically. Release the DOWN button.
Press the DOWN button for 1 second and then release it.
Press the KEINE button for exactly 1 second.
Press the DOWN button for exactly 3 seconds and then release it.
The drive confirms the setup mode with a brief up and down move-
ment.
53
EN