Setting The End Positions With Setting Switch/Switch - Selve commeo SE Breeze-com Originalbetriebsanleitung

Setting the end positions

4.5. Setting the end positions with setting switch/switch

Note: Settings with a wired switch are only possible in automatic setup mode.
When connecting the setting switch for radio drives, the following must be taken into consid-
eration:
Attention! Risk of injury from electric shock!
Only perform connection when free of voltage!
Warning!
The 5 wires in the setting switch cable must be connected to the drive connection cable by
matching the colours.
SELVE setting switch
article no. 290109
Attention: Always connect L1 (= brown) to a continuous 230 V power supply even if the drive
is only being connected to a switch or setting switch for setup purposes.
Note: The following settings can be made with both the SELVE setting switch (article no.
290109) and the new SELVE universal setting switch (article no. 291009).
SELVE universal setting switch
article no. 291009
UP = grey
DOWN = black
N = blue
L1 = brown
PE = yellow/green
Control Up/Down
E button
42