Semi-Automatic Setup Mode Without Relief - Selve commeo SE Breeze-com Originalbetriebsanleitung

Setting the end positions

4.5.2. Semi-automatic setup mode WITHOUT relief

in operation: bottom position, top stop
When the movement is interrupted twice during operation, the system signalises that it is in
semi-automatic setup mode. The drive only finds the upper end position automatically.
Important: A limit stop is required for the upper end position (e.g. box awning)!
The lower end position must be approached first. After pressing the E button on the setting
switch for 3 seconds, move from here to the upper stop without interruption until the drive
automatically switches off.
Operation with Movement
setting switch
E
1 s
E
E
3 s
Press and hold the E button of the setting switch for 1 seconds.
Both previously set end positions are deleted.
Note: Can be omitted during the initial installation or after
resetting to the factory settings.
Move the drive downwards to the required lower end position
using the UP or DOWN button.
STOP
STOP
Press the E button on the setting switch for 3 seconds
(= deactivate the relief in the upper end position).
From here, move to the upper stop without interruption. The
drive stops automatically. This correctly sets the direction of
STOP
rotation. Perform a test run. The drive moves upwards against
STOP
the stop and is no longer relieved.
44