Commeo Commissioning/Setting By Radio; Selecting A Receiver - Selve commeo SE Breeze-com Originalbetriebsanleitung

Inhaltsverzeichnis

Verfügbare Sprachen

commeo commissioning/setting by radio

5. commeo commissioning/setting by radio

commeo commissioning

The commeo can only be put into operation with commeo transmitters. The receiver must be

selected with a transmitter in SELECT mode to configure the settings in the receiver. In SELECT

mode, there is only one connection to a selected receiver. Only this receiver can be moved

and configured.

Pressing the SELECT button for 3 seconds sets the transmitter to SELECT mode. After SELECT

mode has been started, the status LED begins to flash quickly and the transmitter searches

for the receivers. When the status LED lights up green, this indicates that receivers have been

found and the status LED slowly flashes orange. The first receiver makes a short confirmation

run. If no receivers have been found, this is indicated by the status LED lighting up red.

Receiver selection with non-programmed transmitter/initial commissioning

>1 s

Receiver selection with programmed transmitter

1. Select the transmitter channel on which the receiver is programmed.

2. Press the SELECT button on the transmitter for 3 seconds. The transmitter is in

SELECT mode.

3 s

Note: The receivers found with this method can now be found using another non-pro-

grammed transmitter within 4 minutes. To do this, press the SELECT button on the additional

transmitter for 3 seconds. The transmitter is in SELECT mode. All settings can now be config-

ured using both transmitters.

1. Interrupt the voltage supply to the receivers for > 1 second.

The receivers can be found within the next4 minutes.

2. Press the SELECT button on the transmitter for 3 seconds. The

transmitter is in SELECT mode.

3 s

Inhaltsverzeichnis