Manual Setup Mode Without Relief - Selve commeo SE Breeze-com Originalbetriebsanleitung

Setting the end positions

4.5.3. Manual setup mode WITHOUT relief

in operation: bottom position, top position
When the movement is interrupted once, the system signalises that it is in manual setup
mode.
Operation with Movement
setting switch
E
6 s
E STOP
E
3 s
E STOP
E
3 s
Press and hold the E button of the setting switch for 6 seconds.
The drive switches to manual setup mode. Both previously set
end positions are deleted.
Move the drive to the lower end point using the UP or DOWN
button.
Press and hold the E button for 3 seconds.
Note: The lower point is now saved. The direction of rotation
will be set correctly after the end positions have been set.
Move the drive to the upper end point using the UP or DOWN
button.
Press and hold the E button for 3 seconds. The upper point is
now saved and the correct direction of rotation is assigned.
Perform a test run. The drive moves between the two set
points.
45
EN