Commeo Initial Operation (By Radio); Selection Of A Receiver; Programming/Deleting Transmitters - Selve Commeo Se Pro-Rc Originalbetriebsanleitung

EN commeo initial operation (by radio)

6. commeo initial operation (by radio)

commeo initial operation
The commeo initial operation is only possible using commeo transmitters. To com plete
the settings in the receiver, the receiver must be selected with a trans mitter in SELECT
mode. In SELECT mode, there is only one connection at a time to a re ceiver. Only this
one can be moved and set.

6.1. Selection of a receiver

By pressing the SELECT button for 3 seconds the transmitter will be put into the
SELECT mode. After the SELECT mode has been started, the status LED will start to
flash quickly and the transmitter will look for the receiver. The status LED being lit in
green indicates that the receiver has been found and the status LED will flash slowly in
orange. The first receiver completes a brief confirmation run. If no receivers have been
found this will be indicated by the status LED being lit in red.
Receiver selection with non-programmed transmitter/initial operation
➧
>1 s 3 s
or
Receiver selection with programmed transmitter
1. Select the transmitter channel on which the receiver is programmed.
2. Push the SELECT button at the transmitter for 3 seconds. The transmitter
is in SELECT mode.
3 s
Note: The receivers found by this method can now be found using another non­
programmed transmitter within 4 minutes. Press the SELECT button on the additional
transmitter for 3 seconds for this purpose. The transmitter is in SELECT mode. All
settings can now be completed with both transmitters.

6.2. Programming/deleting transmitters

To program or deprogram a transmitter, select the desired channel and push the PROG
button for 1 second. The status LED lights up green to indicate that the transmitter has
been programmed. A red light means that the transmitter has been deprogrammed.
1 s
1. Interrupt the voltage supply of the receivers for
> 1 second. The receivers can be found within the next
4 minutes.
2. Push the SELECT button at the transmitter for 3 seconds.
The transmitter is in SELECT mode.
Status LED transmitter = green  transmitter programmed
Status LED transmitter = red  transmitter deleted
32