Commeo Initial Operation/Setting By Radio; Selection Of A Receiver - Selve commeo SE Pro-com Betriebsanleitung

Inhaltsverzeichnis

Verfügbare Sprachen

commeo initial operation/setting by radio

6. commeo initial operation/setting by radio

commeo initial operation

The commeo initial operation is only possible using commeo transmitters. To com plete the

settings in the receiver, the receiver must be selected with a trans mitter in SELECT mode. In

SELECT mode, there is only one connection at a time to a re ceiver. Only this one can be

moved and set.

By pressing the SELECT button for 3 seconds the transmitter will be put into the SELECT

mode. After the SELECT mode has been started, the status LED will start to flash quickly and

the transmitter will look for the receiver. The status LED being lit in green indicates that the

receiver has been found and the status LED will flash slowly in orange. The first receiver com-

pletes a brief confirmation run. If no receivers have been found this will be indicated by the

status LED being lit in red.

Receiver selection with non-programmed transmitter/initial operation

>1 s

Receiver selection with programmed transmitter

1. Select the transmitter channel on which the receiver is programmed.

2. Push the SELECT button at the transmitter for 3 seconds. The transmitter is in

SELECT mode.

3 s

Note: The receivers found by this method can now be found using another non- programmed

transmitter within 4 minutes. Press the SELECT button on the additional transmitter for 3 sec-

onds for this purpose. The transmitter is in SELECT mode. All settings can now be completed

with both transmitters.

1. Interrupt the voltage supply of the receivers for > 1 second.

The receivers can be found within the next 4 minutes.

2. Push the SELECT button at the transmitter for 3 seconds. The

transmitter is in SELECT mode.

3 s

Inhaltsverzeichnis