Menu Level 3: Operating Mode - Dometic COOLAIR RT780 Montageanleitung

RT780
4. Use the + and – buttons to set the value for low voltage cut-off. The
characteristic figures at second and third place on the display represent the
voltage (V) at which the unit is shut down:
Characteristic
figure
1
2
3
4
5
5. Press the
✔ The set value is saved and is then used when the unit is restarted.
✔ You are now in menu level 2 again and can use the + and – buttons to switch
between menu levels.
7.4

Menu level 3: Operating mode

The unit always starts with a defined operating mode for room temperature. This
parameter can be configured:
1. Start configuration mode (chapter "Starting and ending configuration
mode" on page 11).
✔ The first digit of the display shows the menu level and the second and third
show the parameter which can be set.
2. Press the + button twice to switch to menu level 3.
3. Press the
✔ The digits in the display flash until the parameter you entered is confirmed.
4. Use the + and – buttons to set the mode with which the unit starts up:
Characteristic
figure
0
1
2
3
5. Press the
✔ The set value is saved and is then used when the unit is restarted.
✔ You are now in menu level 3 again and can use the + and – buttons to switch
between menu levels.
EN
Low voltage
cut-off
22.2
22.4
22.6
22.8
22.9
button to confirm your entry.
button to change the parameters.
Operating mode
Automatic mode
Operating mode 1
Operating mode 2
Operating mode 3
button to confirm your entry.
Configuration of unit software
Characteristic Low voltage
figure cut-off
6
7
8
9
10
23.0
23.1
23.2
23.4
23.6
13