Charging The Drive Battery - Reely Speedy Bedienungsanleitung

8. Charging the drive battery

The drive battery is typically empty upon delivery and must be charged. Several complete discharge and
charge cycles are required to ensure that the drive battery reaches its maximum performance.
The drive battery is charged using the supplied USB charger.
Attention!
Do not connect the USB cable to the USB port of a computer/laptop or USB hub because their current is
not high enough for charging.
Use, for example, a commercially available USB power adaptor that provides an output current of at least
2 A.
Only use the included USB charger to charge the Li-ion drive battery as the USB charger is a perfect match
for the Li-ion drive battery.
Never recharge the drive battery unattended.
Insert the drive battery for charging on a fixed base, e.g. a flagstone.
Proceed as follows:
• Disconnect the drive battery from the vehicle, completely disconnect the plug. Remove the drive battery from the
vehicle.
• The drive battery has a special reverse polarity protected plug. Connect the drive battery to the matching socket on
the charging cable of the USB charger. Do not use any force. The plug engages with a clip.
• Connect the USB charger with a suitable USB power adaptor (output 5 V/DC, min. 2 A), then plug it into a mains
socket.
• A red LED on the USB charger indicates the function:
LED glows steadily: Battery is charging
LED goes off: Charging is complete
It takes about 2 hours to charge the empty battery.
• When the Li-ion drive battery is completely charged, disconnect it from the USB charger by pressing the locking clip
and removing the plug. Disconnect the USB charger from the power supply.
31