Declaration Of Conformity (Doc); Troubleshooting - Reely Speedy Bedienungsanleitung

13. Declaration of Conformity (DOC)

Conrad Electronic SE, Klaus-Conrad-Straße 1, D-92240 Hirschau, hereby declares that this product conforms to
Directive 2014/53/EU.
Click on the following link to read the full text of the EU Declaration of Conformity:
www.conrad.com/downloads
Select a language by clicking on the corresponding flag symbol, and then enter the product order number
in the search box. The EU Declaration of Conformity is available for download in PDF format.

14. Troubleshooting

The model does not respond or responds incorrectly
• In the case of 2.4 GHz remote controls, the receiver must be connected to the transmitter. This process is known
as "binding" or "pairing". "Pairing" takes place automatically each time you switch on the transmitter and then the
vehicle.
• Release the throttle/brake lever and the steering wheel on the transmitter. Only then you can turn on the vehicle.
• Is the vehicle drive battery or the transmitter batteries/rechargeable batteries empty? If so, replace the drive battery
or transmitter batteries/rechargeable batteries.
• Is the drive battery correctly connected to the vehicle? Check the plug for soiling or oxidisation; the plug must fully
engage with its clip.
• Is the vehicle too far away? With a fully charged drive battery and batteries/rechargeable batteries in the transmitter,
a 30-metre range should be possible. However, it can be reduced by outside influences, such as interference on the
radio frequency or the proximity of other transmitters (not only remote control transmitters but also Wi-Fi/Bluetooth
devices that also use a transmission frequency of 2.4 GHz), metal parts, buildings, etc.
Vehicle only drives relatively slowly
• Use the left rotary control on the transmitter to set the maximum speed, as described in chapter 10. h).
The vehicle travels slowly or the steering servo does not respond properly to remote control commands; the
range between the transmitter and the vehicle is very short
• The drive battery is nearly empty.
The receiver and the steering servo are powered by the BEC of the integrated speed controller. As a result, the
receiver will not function properly when the drive battery is nearly empty. Replace the drive battery with a fully
charged drive battery (before changing the battery, wait for at least 5–10 minutes for the motor and speed controller
to cool down).
• Check the batteries/rechargeable batteries in the transmitter.
®
39