Changing The Eeprom - Balluff BIS C-60 3 Serie Handbuch

C60_3-025_825645_1310_e.p65
85
Wiring diagram
for BIS C-6003
processors with
BIS C-655 adapter
(2 × 2 Heads)
The ground connector should be connected to earth directly or
through a RC combination depending on the system (potential
counterpoise).
When connecting the bus leads, make sure that the shield has pro-
per connection to connector housing.
86
Changing the
EEPROM in the
BIS C-6003
processor
Location of the
EEPROM
86 english
BIS C-6003
Interface Information / Wiring Diagrams
Connection for Read/Write Head 1.1/1.2
Connection for Read/Write
Head 2.1/2.2
supply voltage, DeviceNet DeviceNet
digital input input output
BIS C-6003

Changing the EEPROM

To replace the EEPROM, open up the processor as described on
Be sure before opening that the unit is discon-
nected from power.
To avoid damaging the EEPROM, please ob-
serve the requirements for handling electrostati-
cally sensitive components.
The EEPROM is replaced by unplugging and
plugging back into the socket.
X1, supply voltage,
digital input
X2, DeviceNet input (male)
Function
ground FE
X3, DeviceNet output (female)
81.
OFF ON
1
2
3
4
5
6
7
8
S1
X1
Pin Function
1 +Vs
2 –IN
3 –Vs
4 +IN
5
Pin Function
1 Drain
2 V+
3 V–
4 CAN_H
5 CAN_L
Pin Function
1 Drain
2 V+
3 V–
4 CAN_H
5 CAN_L
85
english
S2
ON OFF
1
2
Head 1
Head 2
RS 232 Head
X4
X2 X3