Bis C-60_3 Processor Basic Knowledge For Application - Balluff BIS C-60 3 Serie Handbuch

C60_3-025_825645_1310_e.p65
9
Configuration with
BIS C-6023
processor
(connection withT-Port
taps and Drop lines
Schematic
representation of an
identification system
(example)
10
Selecting System
Components
10 english
Introduction
BIS C-6023 Identification Systems
T-Port tap
Drop line
2)
)
Processor BIS C-6023
BIS C-3_ _ BIS C-3_ _
1) BIS C-3_ _ series, except BIS C-350 and -352
2) When connecting the BIS C-6003 Processor per drop line, the DeviceNet output should be closed off with
a cap (see Accessories 97).
BIS C-60_3 Processor
Basic knowledge for application
The BIS C-6003 processor has a plastic housing. Connection is made through round
connectors. A single read/write head from BIS C-65_ series can be directly mounted to the
processor, which creates a compact unit. If the BIS C-650 adapter is attached instead of the
BIS C-65_ read/write head, two read/write heads may be cable connected. If the BIS C-670
adapter is attached, one read/write head may be cable connected.
The BIS C-6023 processor has a metal housing. Connection is made through round connec-
tors. Two read/write heads can be cable connected to the BIS C-6022 processor.
Series BIS C-60_3 processors have in addition a digital input. This input can be used to
perform a hardware reset of the Processor.
Whether the compact version of the processor with integrated read/write head makes sense
or whether the external solution is preferred depends primarily on the spatial arrangement of
the components. There are no functional limitations. All read/write heads are suitable for both
static and dynamic reading. Distance and relative velocity are based on which data carrier is
selected. Additional information on the read/write heads in series BIS C-65_ and series
BIS C-3_ _ including all the possible data carrier/read-write head combinations can be found
in the manuals for the respective read/write heads.
The system components are electrically supplied by the processor. The data carrier represents
an free-standing unit and needs no line-carried power. It receives its energy from the read/
write head. The latter constantly sends out a carrier signal which supplies the code head as
soon as the required distance between the two is reached. The read/write operation takes
place during this phase. Reading and writing may be dynamic or static.
DeviceNet
Trunk line
Processor
Read/write heads 1) BIS C-3_ _
Data carriers BIS C-1_ _
T-Port tap
BIS C-6023
BIS C-3_ _
9
english