Mounting Head / Processor; Opening The Processor - Balluff BIS C-60 2 Serie Handbuch

C60_2-028_823024_0401-e.p65
49
Orientation of the
read/write head or
adapter
Mounting the
BIS C-6002
processor
50
Opening the
Processor
BIS C-6002

Opening the processor

50 E
BIS C-6002

Mounting Head / Processor

Depending on model, the processor is equipped with a read/write head or the adapter for
offset read/write heads. Both the read/write head and the adapter can be rotated by the user
by + or –90 deg. to the desired
position (see drawing). Be sure
that power is off first. Loosen
both screws (indicated with
arrows). Carefully pull the head
or adapter out towards the side
(direction of arrow, right draw-
ing).
Caution: wires inside!
Reattach at the desired orienta-
tion and screw tight again.
The processor is attached using
4 M4 screws.
BIS C-6002
Opening the Processor
The BIS C-6002 processor must be opened to perform the following steps:
– Set PROFIBUS-DP address
– Activate/deactivate termination resistor
– Set/change compatibility mode
– Replace EEPROM
– Make electrical connections (supply voltage, in-/output,
PROFIBUS-DP connections).
Be sure that the unit is disconnected from power before
opening.
Remove the 4 screws on the BIS C-6002 and lift off the
cover.
Perform the desired action. To make the electrical connec-
tions, push the cables through the fittings. For additional
wiring details, see the following
Mounting of the cover (4 screws),
max. permissible tightening torque: 0.15 Nm
Caution: wires inside!
X3
.
19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1
E 49
Head 1
Head 2