Balluff BIS C-60 2 Serie Handbuch Seite 74

C60_2-028_823024_0401-e.p65
71
Changing the
EEPROM in the
BIS C-6022
processor
Location of the
EEPROM
72
Dimensions, weight
Operating conditions
Enclosure
Connections
BIS C-6022-...-ST10
Connections
BIS C-6022-...-ST14
Electrical
connections
with ST10 only:
72 E
BIS C-6022
Changing the EEPROM
To change the EEPROM, open the processor as described on
Be sure before opening that the unit is
disconnected from power.
To avoid damaging the EEPROM, please
observe the requirements for handling
electrostatically sensitive components.
The EEPROM is replaced by unplugging
and plugging back into the socket.
BIS C-6022
Technical Data
Housing
Dimensions
Weight
Ambient temperature
Protection class
Integral connector X1 for V , CT Present_, +IN
S
Round connector X2 / X3 for PROFIBUS-DP
Integral connector X4 for Service interface
Integral connector X1 for V , +IN
S
Integral connector X2 for PROFIBUS-DP input
Integral connector X3 for PROFIBUS-DP output
Integral connector X4 for Service interface
Supply voltage V
S
Ripple
Current draw
Control outputs CT Present 1 and 2
Output circuit
Operating voltage V for output
S
Ripple
Output current
Voltage drop at 20 mA
Output resistance R
A
66.
Head 2 Head 1
1
2
3
X1
4
5
6
7
8
S1
Head 1
X2
Head 2
19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1
S2
X3
X4
Metal
190 x 120 x 60 mm
820 g
0 °C to +60 °C
IP 65 (when connected)
5-pin (male)
12-pin (female)
4-pin (male)
5-pin (male)
5-pin (male)
5-pin (female)
4-pin (male)
DC 24 V ± 20 %
≤ 10 %
≤ 400 mA
Optocoupler isolated
PNP (current sourcing)
DC 24 V ± 20 % via X1
≤ 10 %
max. 20 mA
approx. 2.5 V
10 kΩ to –V
S
E 71