AP 40
2. Filter einsetzen
2. Installing filters
Dieses Produkt erhalten Sie mit allen erforderlichen Filtern. Bevor Sie diese
This product comes with all of the required filters. The protective plastic wrap must be
benutzen, entfernen Sie bitte die jeweilige Plastikfolie.
removed from the filters before use.
Sollten Sie die Plastikfolien nicht entfernen, könnte es zu Betriebsstörungen
Operating the unit without removing the plastic wrap may result in product failure.
kommen. Stellen Sie sicher, dass das Gerät ausgeschaltet ist, bevor Sie die
Unplug and make sure the unit is turned off before installing filters.
Filter einsetzen.
Sie öffnen die Frontblende, indem
A
Remove the front panel by grasping
①
Sie den oberen Rand ergreifen
its upper edge and gently pulling
und leicht herausziehen.
forward.
Um die Frontplatte zu entfernen,
To remove the front panel, the latch
muss der Riegel am unteren Rand
at the lower edge of the panel must
muss entfernt werden.
be released from its position.
B
Um den
Press the tabs on the top edge to
②
zu entnehmen, drücken Sie die
remove the
beiden obenstehenden Klips.
Entnehmen Sie die abgepackten
C
Pull out the new filters covered in
②
Filter aus dem Gerät.
plastic wrap.
Entfernen Sie die Plastikfolie des
D
Remove the plastic wrap from the
③
neuen Filters.
new filters.
Sollten Sie das Gerät mit dem
Operating the unit without removing
eingepackten Filter betreiben, kann
the plastic wrap from the filters may
es zu abnormalen Geräuschen,
cause abnormal noise, deformation, or
Verformungen oder Feuer führen.
fire from overheating.
®
CleanCel
Fein Filter
Pre-filter.
ProSource Packaging, Inc.
14911 Stuebner Airline Rd. Ste. A
Houston, TX 77069
Riegel
Latch
- 14 -
Phone: (281) 453-8801
www.machine-solution.com
Klips
Tabs