Steering Wheel; Tyre Pressure; Accessories; Controls - Stiga Villa 320 HST Gebrauchsanweisung

EN
5 .5

STEERING WHEEL (7)

Install the steering wheel as follows:
1 . Put the sleeve (7:B) on the steering column.
Align the holes on the sleeves with those on
the steering column using a pin punch (7:C)
or similar tool.
• Model 320: the height position can be
selected from 4 sets of holes. Select the
position which suits you most.
• Model 520: use the bottom set of holes.
2 . Secure the sleeve to the steering column
using the pins (7:A).
5 .6

TYRE PRESSURE

For the tyre pressure, please refer to "0 TECHNI-
CAL DATA TABLE".
5 .7

ACCESSORIES

For installation of the accessories, please refer to
heading 6.13.1.
Note: In this case the cutting deck is
considered an accessory .

6 CONTROLS

6 .1 MECHANICAL ACCESSORY LIFT PE-
DAL (8:C)
It controls the lift system and is used to take
the accessories from the operating position
to the transport position.
• Transport position: press the pedal right
down then lift your foot off: the pedal stays
down.
• Operating position:
• Press the pedal right down.
Move the locking lever (8:B) to the left.
•
• Release the pedal.
Do not attempt to switch to the tran-
sport position while the hooked-up
accessory is in operation. This will de-
stroy the drive belt .
6 .2 PARKING BRAKE PEDAL (8:D)
Never press the pedal while driving.
There is a risk of overheating in the po-
wer transmission.
12
ENGLISH
The pedal (8:D) has the following two positions:
locked.
6 .3

PARKING BRAKE LOCKING LEVER

(8:A)
This locks the parking brake pedal in the
pressed right down position.This function is
used to lock the machine on slopes, during
transport, etc., when the engine is not run-
ning.
Locking:
1 . Press the pedal (8:D) right down.
2 . Move the locking lever (8:A) to the left.
3 . Release the pedal (8:D).
4 . Release the locking lever (8:A).
Unlocking:
Press and release the pedal (8:D).
6 .4 TRACTION PEDAL(8:G)
The pedal determines the gearing ratio between
the engine and the drive wheels (= the speed).
When the pedal is released, the service brake is
activated.
Reduce the pressure on the pedal – the machi-
ne brakes.
A plate is installed on the upper section of the pe-
dal which can be adjusted to suit the driver's foot.
6 .5 STEERING WHEEL - mod .: [520]
The height of the steering wheel is fully adjustable.
Unscrew the adjustment knob (8:H) on the steering
column and raise or lower the steering wheel ac-
cordingly. Tighten.
Do not adjust the steering wheel when
the machine is running .
Never turn the steering wheel when the
machine is stationary with a lowered
implement . There is a risk of abnormal
loads on the servo and steering mecha-
nisms .
(Translation of the Original Instructions)
Released: The parking brake is
not activated.
Pressed right down. Forward
drive disengaged. The parking
brake is fully activated but not
- Press the pedal forward – the
machine moves forward.
- No load on the pedal – the ma-
chine is stationary.
- Press the pedal backward – the
machine reverses.