SOLIS GRILLMASTER TOP 794 Bedienungsanleitung Seite 111

Note to the temperature unit:
Your grill is equipped with a temperature unit switch (F), which can be found to
the lower left of the LCD screen. Standard temperature setting is Celsius, al-
though it can be changed to Fahrenheit by pressing the switch (F). The resp. in-
dicator °C or °F will be displayed.
If you have set the temperature display to Fahrenheit, it will save this setting un-
til you press the switch again or pull the power plug. After reconnecting the plug
to the wall outlet, the standard setting Celsius will be displayed again.
7. If necessary, adjust the angle:
While the appliance heats up, you can adjust the bottom plate's angle with the
tilt lever (J). Your can operate your appliance completely flat („FLAT") or tilt it
slightly to the back („ANGLE"). The lever is at the rear right side of the grill.
Note to the ideal angle:
If the bottom hot plate is tilted, meaning the lever is set to „ANGLE", fat from
fatty foods like f.e. meat can easily drain into the grease drip tray.
If the bottom hot plate is flat, meaning the lever is set to „FLAT", foods like eggs,
pancakes, bread or fatless foods can be ideally prepared.
Fat or juice drains through the opening in both hot plates into the grease drip
tray.
8. Pre-heating phase is completed:
A signal will sound and the HEATING notice will
disappear once the grill has reached the set
temperature. The LCD screen will display the set
temperature and „0" for the time setting.
Note: Always let your grill heat up to the set
temperature before placing foods on the grill.
This means you have to wait for the HEATING
notice to disappear from the display.
Note: The HEATING notice might flash during grilling. This is normal and sim-
ply indicates that the set temperature is being constantly kept.
9. How to fully open the hot plates for BBQ usage:
a) Wait for the hot plates to completely heat up
and the HEATING notice to disappear.
b) Check if the upper hot plate is closed, mean-
ing it's lying evenly on the bottom one, and en-
sure that the lever for opening and closing the
hot plates (L) is set to „OPEN". To completely
open the hot plates, this lever has to be moved
to the position „BBQ". Proceed as follows:
111