Lift Setting - Gude DHH 1050/11 T ECO Bedienungsanleitung

Handling

Lift setting

The working output can be increased by reducing the
splitting knife reverse running for pieces of wood smaller
than app. 50 cm and when more wood needs to be split.
Proceed as follows:
Put a short piece of wood on the splitting table, move the
splitting knife approximately 2 cm above the wood and
switch the knife off (press the red button on the switch and
pull the plug out of socket). Using a side rod, you can now
shorten the reverse running by fixing the rod in the desired
height by adjusting screw.
Safety instructions for first starting up
Check the functionality of safety devices (especially the two-lever control) before starting your work.
Safety instructions for handling
• Use the machine only after you have carefully read the Operating Instructions.
•
Follow the safety instructions specified in the manual.
•
Behave responsible towards other persons.
•
Wood can only be split along the fibre.
•
Risk of getting jammed when splitting knotty wood.
Jammed pieces of wood to be released by knocking on them.
Cutting out these pieces prohibited!
•
Risk of split wood getting jammed. When releasing please be aware the wood is heavily stressed
and your fingers can get squeezed in the split slot.
•
The machine has been designed to be operated by one person only; operation by two or more
persons strictly prohibited.
Make sure the splitting table is always secured properly. A falling splitting table or falling piece of
wood can injure your legs.
Caution:
Caution:
Tip:
Hard wood can strongly hit you when splitting.
Working without the splitting cross is recommended for long pieces of hard wood.
Never use the splitting wedge extension along with the short wood table in
the highest position.
More problem wood can be split after knife lubricating!