Area Of Use; Operation; Lift Setting - Gude DHH 1050/7 T MBS Bedienungsanleitung

5. Area of Use

The machine is approved for wood processing only. The material to be cleaved shall be of dimensions as follows:
Minimum diameter: 120 mm
-
Maximum diameter: 300 mm
Wood is permitted to be cleaved in the direction of grain only.
-
There is a risk of jamming of branchy wood while being cleaved .
-
The jammed pieces may be knocked/banged out
-
Never cut it out with a saw !
-
Cleaving Length Set-up
Various length of wood pieces may be cleaved:
Type DHH 1050/6 TC
Cleaving length ca 1050/810/560 mm.

6. Operation

Start the motor following the directions in the manual.
1. At low temperature, let the motor idle for about 15 minutes for the oil to get warmed up.
2. Lay a piece of wood to be cleaved on the table and hold it to the lever using anchoring wires/grabs☺.
3. Start cleaving pushing both the levers downward.
4. With cleaving completed, lift one lever at least, the cleaving column will go up automatically.
It is strictly forbidden for two persons operate the machine at a time, when one would hold the wood and the
other one would operate the wires/grabs. Never block the lever (anchoring wire/grab).

7. Lift Setting

With pieces up to ca 50 cm long or a bigger quantity, it is possible to
increase the working capacity by making the cleaving knives reverse
shorter.
Model DHH 1050/6TC with control rods
Procedure is as follows:
Lay a short piece of wood on the table, lower the knife down to be at a
distance of ca 2 cm above the piece and put the machine off. Now, you
may adjust the reverse using the side rods fixing the rod at a required
height with an adjusting screw.
5
GB