Bosch VitaPower 8 Serie Gebrauchsanleitung Seite 27

Warning!
– No antibacterial effect results from
vacuum application.
– Keep such food in the refrigerator and
regularly check that it is still fresh!
– Storage in vacuum is not a substitute
for food storage in the refrigerator or
freezer.
– Always allow food to cool down before
vacuum-sealing.
Vacuuming the ToGo bottle or
storage containers
X Image sequence F
1. Add prepared or cooked food to the
container required.
2. ToGo bottle: Fit the lid with the drinking
cap and close securely. Fold up the lid.
3. Containers: Fit the lid and close
securely. Set the date using the two
rings on the lid.
4. Open the cap completely.
5. Fit the vacuum hose onto the vacuum
valve.
6. Close the cap. Fit the hose onto the
ToGo bottle or the lid of the container.
7. Set the rotary selector to 0. Switch on
the appliance with
8. Press
9. The vacuum pump draws the air out of
the container. The
The status display LEDs light up one by
one.
Note: If the preset vacuum level is
not reached, the
up and 2 short signal tones sound.
X "Troubleshooting" see page 31
10. All status display LEDs are lit. The
preset vacuum level is reached.
11. Switch off the appliance using
Disconnect the mains plug.
12. Remove the hose from the ToGo bottle
or container. Hold the cap securely and
remove the hose from the vacuum valve.
button.
button.
symbol lights up.
symbol then lights
button.
Storage with vacuum
Vacuum-sealing with zipper bags
X Image sequence H
1. Add the food to the bag.
Note: Do not overfill the bag. Make sure
the area of the vacuum seal is kept clean.
Special care is needed when vacuuming
juicy, moist or marinated food.
2. Place the bag on a flat surface. Lightly
press the air out of the bag and close
the zip lock tightly along the entire
length.
Note: When vacuuming juicy, moist or
marinated food, hang the vacuum zipper
bag from the worktop. Make sure that
the vacuum seal rests on the surface.
X Fig. I
Important!
– The contents must not exceed the max
marking line.
– The area beyond the max line and both
sealing elements must be clean.
– If zip lock is not clean and completelly
closed, vacuum cannot be generated.
3. Open the cap completely.
4. Fit the vacuum hose onto the vacuum
valve.
5. Close the cap.
6. Place the connection of the vacuum
hose on the vacuum seal of the bag and
hold securely.
7. Set the rotary selector to 0. Switch on
the appliance with
8. Press
9. The vacuum pump draws the air out of
the bag. The
status display LEDs light up one by one.
Note: If the preset vacuum level is
not reached, the
up and 2 short signal tones sound.
X "Troubleshooting" see page 31
10. All status display LEDs are lit. The
preset vacuum level is reached.
11. Switch off the appliance using
Disconnect the mains plug.
button.
button.
symbol lights up. The
symbol then lights
button.
en
27