Storage With Vacuum - Bosch VitaPower 8 Serie Gebrauchsanleitung

en

Storage with vacuum

Manual blending with vacuum
function
X Image sequence D
1. Set the rotary selector to 0. Switch
on the appliance with
indicators light up briefly once and a
short signal tone sounds. The
lights up.
2. Press
lights up.
3. The vacuum pump draws the air out of
the blender jug. The status display LEDs
light up one by one.
Note: If the preset vacuum level is
not reached, the
up and 2 short signal tones sound.
X "Troubleshooting" see page 31
4. All status display LEDs are lit. The
preset vacuum level is reached.
5. Set the rotary selector to the required
level or . The higher the speed, the
more status display LEDs are lit.
6. Process the ingredients until the desired
consistency is achieved.
7. Set the rotary selector to 0. Wait until
the appliance comes to a standstill.
■ Switch off the appliance using
Disconnect the mains plug.
■ Perform steps from 8. as described.
X "Blending with automatic
programme" see page 25
Using the Pulse function
■ Turn the rotary selector anticlockwise to
the position
■ The appliance will run at maximum
speed for as long as the rotary selector
is held.
■ Release the rotary selector.
Blending without vacuum
function
Prepare blender as described.
X "Preparation" see page 24
X Image sequence E
1. Set the rotary selector to 0. Switch on
the appliance with
26
button. All
button
button. The symbol
symbol then lights
button.
and hold.
button.
2. Set the rotary selector to the required
level or . The symbol
The higher the speed, the more status
display LEDs are lit.
Note: During processing hold the blender
securely by putting one hand on the cap.
3. Process the ingredients until the desired
consistency is achieved.
4. Set the rotary selector to 0. Wait until
the appliance comes to a standstill.
5. Switch off the appliance using
Disconnect the mains plug.
6. Open the cap completely.
7. Turn the blender jug anticlockwise and
remove.
8. Pull the lid by the lug to remove. Pour
the blended food into another container.
■ Clean all parts. X "Cleaning and
maintenance" see page 28
Making crushed ice
Prepare the blender as described and add
ice cubes. X "Preparation" see page 24
■ Set the rotary selector to 0. Switch on
the appliance with
■ Press button. The symbol
up.
■ The blender automatically starts
processing and crushes the ice cubes
in a pulsing rhythm. The status display
LEDs light up one by one.
■ The blender ends processing
automatically. Wait until the appliance
comes to a standstill.
■ Switch off the appliance using
Disconnect the mains plug.
■ Perform steps from 8. as described.
X "Blending with automatic
programme" see page 25
Storage with vacuum
A vacuum can be applied to the ToGo bottle,
storage containers and vacuum zip bags
with the blender to preserve the freshness
and extend the shelf life of food contained in
them.
lights up.
button.
button.
lights
button.