Use - Bosch VitaPower 8 Serie Gebrauchsanleitung

4. Fit the lid of the blender jug onto the
blade insert.
5. Rotate the blade insert clockwise to the
stop with the help of the lid.
6. Remove the lid.
Important: The recesses on the blade
insert must be aligned with those on the
blender jug.
7. Turn the blender jug up the right way
and position on the drive as shown.
Marking pointing to
8. Rotate the blender jug clockwise to the
stop. Marking
9. Prepare the food and add to the blender
jug. Do not exceed the marking
Note: Always blend food with sufficient
liquid as this will produce a better result.
When adding ingredients liable to froth up
such as milk and dairy products, do not
exceed the marking
10. Fit the lid and press on firmly. Observe
the recess on the handle when doing so.
Note: The lid can only be fitted in this
position.
11. Close the cap and press down to the
stop.
12. Insert the mains plug.
Note: The blender can only be used if the
following conditions are met.
– The blade insert and lid must be
properly connected to the blender jug.
– The blender jug must be properly
connected to the base unit.
– The cap must be completely closed.

Use

Note: Table N shows further examples
of application. The preparation can be
carried out with an automatic programme or
manually in single steps (1, 2, 3).
Usage informations:
– This appliance is not suitable for making
mayonnaise.
– This appliance is not suitable for
cutting and chopping semi-solid or
solid food (parsley, onion, meat, nuts,
parmesan cheese), but could be used in
combination with liquids. X Table N
.
pointing to .
.
– This appliance is not suitable for
making nuts spreads (hazelnut cream,
nutella, ...).
Blending with automatic
programme
X Image sequence C
1. Set the rotary selector to 0. Switch
on the appliance with
indicators light up briefly once and a
short signal tone sounds. The
lights up.
2. Press
symbols light up.
3. The vacuum pump draws the air out of
.
the blender jug. The status display LEDs
light up one by one.
Note: If the preset vacuum level is
not reached, the
up and 2 short signal tones sound.
X "Troubleshooting" see page 31
4. The status display lights up halfway. The
preset vacuum level is reached.
5. The blender starts processing
automatically and blends the ingredients
in a pulsing rhythm. The second half of
the status display gradually lights up.
6. The blender ends processing
automatically. Wait until the appliance
comes to a standstill.
7. Switch off the appliance using
Disconnect the mains plug.
8. Open the cap completely.
9. Turn the blender jug anticlockwise and
remove.
10. Grip the vacuum seal at one end and
pull it up. Sufficient air has to get inside
the blender jug for the lid to be removed.
11. Pull the lid by the lug to remove.
12. Pour the blended food into another
container.
■ Clean all parts. X "Cleaning and
maintenance" see page 28
Note: To keep the food fresh, put it in the
ToGo bottle or storage containers after
processing and apply a vacuum again.
X "Storage with vacuum" see page 26
Use
button. All
button. The and
symbol then lights
en
button
button.
25