Flask Supports - Heidolph LABOROTA 20 control automatic Betriebsanleitung

E
X

45. Flask supports

The flask supports make flask (1) removal (even filled) an easy job for one person.

Uninstall flask: Open enclosure (2). Engage drive lock (8). Slide support pipes (4) to flask (1)
from both sides. Check for firm contact and lock support pipes in place by tightening
thumbscrews (5) CW. Unscrew large coupling ring (6, not shown) by turning CCW. Tilt flask
neck with large coupling ring (6) forward. Remove flask carefully (coupling ring to remain on
flask).

Install flask: Open enclosure (2). Engage drive lock (3). Move support pipes (4) (both sides) to
the respective flask size mark (center of thumbscrew = mark). Mark I = 10 l flask; mark II = 20 l
flask. Lock support pipes in place by tightening thumbscrews (5) CW. Put flask (1) , holding
All manuals and user guides at all-guides.com
A
Y
1
4
5
7
Z
8
114
2