Heidolph LABOROTA 20 control automatic Betriebsanleitung Seite 102

E
OFF
OFF
OFF
OFF
00:00
nd
2 step:
Now, select the LED Set Ramp Time by pressing the Select key next to Display Time repeatedly.
The time for the 2nd step of programming can be changed with the Set increase or Set decrease
keys.
After 5 seconds with no entry, the display returns to Act Condition. The last value is accepted.
Additional steps:
Additional steps can be programmed in the same manner as step 2.
Select Set Ramp Time LED to program the next time.
For complex ramps, we recommend you to use the form enclosed (for convenience). The same
page shows an example.
Note: Values only can be programmed that had been activated at 00:00 before.
Parameters, which were programmed as a ramp, cannot be changed during the process of the
ramp with the „Set Function". Parameters that are not programmed as a ramp can be changed at
any time with the „Set Function"
All manuals and user guides at all-guides.com
102
key Select for Set Vacuum
using p const
key Select for Set ΔT auto
using T auto
key Select for
Set Bath
key Select for
Set Speed