Charging The E-Bike Battery - Urban Arrow Shorty Gebrauchsanweisung

Charging the e-bike battery

7.2
Before you use the e-bike battery for the first time you need to
check the battery before you can charge it fully. Checking is done as
follows:
1. Press the on/off button 53 to switch on the battery. At least
one of the LEDs will light up.
2
When no LED of the charge-control indicator 52 lights up, the
battery may be damaged. Contact your Urban Arrow dealer.
There are two ways of charging the e-bike battery (see image 28):
● Charging while the battery is placed in the battery holder on
the e-bike.
● Charging the battery after you removed it from the e-bike.
6
Before each use, check the battery charger, cable and plug. If
damage is detected, do not use the battery charger. Damaged
battery chargers, cables and plugs increase the risk of an
electric shock. Never open the battery charger yourself.
Contact your Urban Arrow dealer when your battery charger
is damaged.
6
Keep the battery charger clean. Contamination can lead to
danger of an electric shock.
6
Always keep the charger away from rain or moisture. The
penetration of water into a battery charger increases the risk
of an electric shock.
User manual
All manuals and user guides at all-guides.com
6
6
1
Image 28: Charging a battery
2
2
A sticker in English is adhered to the bottom of the charger
(see 32 in image 1). This says: Use ONLY with BOSCH lithium-
ion batteries.
Do not expose the charger to rain or wet conditions. If water
enters a charger there is risk of electric shock.
Use caution when touching the charger during the charging
procedure. Wear protective gloves. Especially in high ambient
temperatures, the charger can heat up considerably.
The e-bike battery is equipped with a temperature control
indicator, which enables charging only within a temperature
range between 0 °C and 40 °C. The battery can be recharged
at any time without shortening the lifespan and interrupting
the charging process does not damage the battery.
The electrical drive unit is deactivated during the charging
procedure.
EN
43