28 7.3 Changing The Battery Of The Purion Display - Urban Arrow Shorty Gebrauchsanweisung

Image 30: Plugging charger plug in charge socket on the battery
Charging state of the e-bike battery
The e-bike battery can be charged with or without the display.
When charging without the display, the charging procedure can be
observed on the battery charge-control indicator 52 . When charging
with the display the bars on the display show the progress as well.
2
The Intuvia display can be removed during the charging
procedure or fi tted after the charging procedure has started.
Each continuously lit LED on the charge-control indicator 52 is
equivalent to a charge capacity of approx. 20 %. A fl ashing LED
indicates the charging of the next 20 %. Once the e-bike battery
is fully charged, the LEDs extinguish immediately and the display
(in case mounted) is switched off. The charging procedure is
terminated.
User manual
All manuals and user guides at all-guides.com
After charging
The procedure after the charging procedure is terminated is as
follows:
2
7.3
The Purion display is supplied with voltage by two CR 2016 button
cells. When the display shows the text ' low bat ' the two batteries
need to be replaced. Changing the batteries is done as follows:
1. Disconnect the charger from the main power supply.
2. Disconnect the battery from the charger. The battery
automatically switches off.
3. If you have charged the battery while placed in the battery
holder on the bike, carefully close the charge socket with the
cover so no dirt or water can get into the charge socket.
Once the battery is charged it will switch off. If the charger
is not disconnected from the battery after charging, after
a few hours the charger will switch itself back on, check
the charging state of the battery and begin the charging
procedure again if necessary.
Changing the battery of the Purion display
1. Unscrew the fastening screw 92 of the display.
2. Remove the display from the handlebar 115 .
3. Open the battery compartment cover 90 by using a coin and
turning it counter clockwise (see image 31).
4. Remove the used battery and insert two new CR 2016
batteries.
EN
45