Initial Use - Beurer BM 45 Gebrauchsanweisung

6. Initial use

Inserting the battery
• Open the battery compartment lid.
• Insert four 1.5 V AA (alkaline type LR6) batteries. Make sure
that the batteries are inserted the correct way round in ac-
cordance with the markings.
Do not use rechargeable batteries.
• Carefully close the battery compart-
ment lid again.
• All display elements are briefly dis-
played, 24h flashes in the display. Now
set the date and time as described
below.
If the low battery indicator
can no longer perform any measurements and must replace
the batteries. Once the batteries have been removed from
the device, the time must be set again. Any saved measured
values are retained.
Operation with the mains part
You can alternatively also operate this device with a mains part
(not included in delivery). However, before connecting the de-
vice with the mains part, please ensure that you have removed
the batteries from the device. During mains operation, there
must not be any batteries in the battery compartment, as this
could damage the device.
• To avoid any potential damage, the device may only be
operated with a mains part that meets the specifications
described in the chapter "Technical specifications".
4 x 1,5V AA (LR06)
is permanently displayed, you
• Furthermore, the mains part must only be connected to the
mains voltage that is specified on the type plate.
• First, remove the protective cap of the mains part connec-
tor – located on the rear of the device – and insert the mains
part into the connection intended for this purpose.
• Then insert the mains plug of the mains part into the mains
socket.
• After using the blood pressure monitor, unplug the mains
part from the mains socket first and then disconnect it from
the blood pressure monitor. As soon as you unplug the
mains part, the blood pressure monitor loses the date and
time setting but the saved measured values are retained.
Setting the hour format, date and time
It is essential that you set the date and time. Otherwise, you
will not be able to save your measured values correctly with a
date and time and access them again later.
There are two different ways to access the menu from
which you can adjust the settings:
• Before initial use and after each time you replace the
battery:
When inserting batteries into the device, you will be
taken to the relevant menu automatically.
• If the batteries have already been inserted:
With the device switched off, press and hold the
START/STOP button
In this menu you can adjust the following settings in succes-
sion:
Hour format
➔
26
for approx. 5 seconds.
Date Time
➔