Carrier XCT7 Installations- Und Benutzerhandbuch Seite 12

Installation instructions
Note:
1. In snowy areas, install the unit under the bracket or the snow-proof cover to prevent the snow from accumulating on the
unit.
2. Do not install the unit in places with the possibility of gas leakage.
3. Install the unit in a sturdy space.
4. Install the unit on a flat surface.
5. When installing in places with strong winds, set the air outlet of the unit perpendicular to the wind's direction.
6. The installation site should be far away from place with a lot of noise. Simultaneously, also ensure that the walls are
insulated to prevent vibration caused by a thin wall or acoustic problems.
7. Aluminium foil fin is very sharp; be careful and avoid scratches.
(3) Installation and maintenance space
Selection of installation location for outdoor unit
(1) Single-unit installation (unit: in.(mm))
Back
Front & back
The top and two side surfaces must be exposed to open space, and barriers on at least one side of the front and back
shall be lower than the outdoor unit.
(2) Multi-unit installation (unit: in.(mm))
Back & side
Above Above
Above
6(150) 12(300) 12(300)
Height of barriers is below that of outdoor unit
Front
When barriers exist above the unit
Above 6 (150)
Above
12(300)
Above 6 (150)
Above
40 (1000)
Front & back
Above12(300)
5
Back & Side
Height of barriers
is below that of
Above 12 (3000)
Above12(300)
outdoor unit