On-Board Computer; Switching Drive Unit On/Off - Gazelle Easyflow HMS Benutzerhandbuch

34

3.8 On-board computer

Your bike is fitted with a Shimano SC-E5000 on-board
computer.
" " To read the display well you can tilt
REMARK
the on-board computer
To do this, loosen the socket screw a little.
3.8.1

Switching drive unit on/off

" " Before using the bicycle, please first
DANGER
read 'Cycling', section 3.10 (page 40).
" " The power for the entire system can be
REMARK
switched on and off only by the on/off button.
The drive unit may only be activated if the following conditions
have been met:
•
A sufficiently charged battery has been installed; see 'Using
the battery', section 3.4 (page 29).
•
The speed sensor has been connected correctly.
Easyflow HMS
back and forwards.
14
Switching on drive unit:
61 60
To switch on the drive unit:
1. Press the battery on/off button
The LEDs of the charge indicator
indicate the charge status.
" " If the battery capacity is low, no LED of
REMARK
the charge status will light up on the battery. Only
the on-board computer will then indicate whether
the drive unit is switched on.
2. Set the assistance level: See 'Selecting desired assistance
level', section 3.8.2 (page 35)
.
60
will light up and
61