Operation; Basics - Bosch Rexroth IndraControl VCP05.2 Projektierungsbeschreibung

26/38 Bosch Rexroth AG | Bedienoberfläche Schweissen / Resistance welding user interface VCP05.2 | R911172348

Operation

6 Operation
6.1

Basics

When the VCP05.2/RS232 operator terminal is switched on, the Start menu
appears:
F1 - Weld sequence/monitoring
F2 – Correction
F3 – Electrodes
F4 – Last weld/Logs
F5 – Extension
F6 – Service
=> Continue with function keys.
When the VCP05.2/ETH operator terminal is switched on, the
menu is displayed first. After entering the weld timer number, use the [F6] function
key to get to the " Start menu" .
Service
Under another selection menu is displayed, continue with [F1] ... [F6].
The [F1] ... [F6] function keys are consistently assigned the same functions.
These functions can be called up from all menus except for
Grouping of functions: related menus are assigned to one function key and can
be called up by pressing the key repeatedly – refer to 7.2.
In order to activate the editing mode, it is first necessary to press the "Data
release"
special key. An entry using the editing keys is only possible when the "Data
release" status LED is on. Press the
mode.
The cursor keys are used to move the editable field in the menu.
For parameter input, use the digit keys or
On/Off Standard/Mix
For switching to ,
Acknowledge by pressing
Entering numbers digit by digit is not possible. If navigation is continued without
acknowledgment, the previous value will remain.
Help is displayed for as long as the [Help] key is pressed.
For message display, use
again.
To return to the "Start menu" from all menus, use
The "Rexroth" screen saver appears if no key is pressed for 5 minutes. Use any
function key to the current menu.
Data release
key again to leave the editing
and .
etc. use and
.
. Return to the previous menu by hitting the key
.
Select weld timer
Service
.
.