Use Instructions; Positioning The Machine; Connecting The Machine; Adjustments - FLAEM NUOVA Magic Vac P0608ED Betriebsanleitung

Warning: When not using the machine, keep the Handles (1) in the STORAGE position. Do not close
completely in order to avoid damaging the Airtight Gasket (7).
Before each use, carefully clean your machine and accessories that come in contact with food (canisters,
lids, jars, etc....) following the instructions provided in paragraph "CLEANING INSTRUCTIONS".

1 - Positioning the machine

Position the machine in a dry place on a horizontal surface, being careful to leave the work zone around
the machine itself free of obstacles and wide enough to allow for placing the bags of food to be packaged.
Connect the power cable to an electrical outlet corresponding with its voltage (see the information label).

2 - Connecting the machine

Insert the Power Cable Plug (17) in the outlet. Check for correct connection by rotating the Handles (1) in
the START position; on the Display of the Mod. P0608ED, the GREEN ON LED (2a), the BLUE LED (20) for
the "turbo" pump speed and the RED LED (2L) for the "humid

3 - Adjustments

Adjustments to the Mod. P0608ED must be selected each time a packing cycle is started. These, in fact,
reset the Handles (1), rotating them to the OPEN position.

3.1 - Setting the sealing mode

The Mod. P0608ED is equipped with an intelligent sealing function that auto-adjusts the sealing
according to the temperature of the Sealing Bar which increases little by little with consecutive packing
cycles. Therefore, the final bag sealing result can be influenced by the type of food to be packed or the
temperature of the room.
Thus, to optimise the final result you can choose form 3 sealing modes:
• "dry" for dry foods like cookies, rice and coffee.
• "humid " for cheeses, dry meats and salami.
• "humid " for red meats, which have liquids or blood, and fish.
When the machine is turned on, the sealing option is always set to "humid
To set the sealing mode, before starting the packing
cycle, press the "sealing mode" button (2M) to select
the mode desired (fig. A).
ATTENTION: The sealing mode selected remains
memorized until the Handles (1) are rotated to the
OPEN position. The selection must be done at every
packing cycle

3.2 - Set the Pump suction Speed

The Mod. P0608ED is equipped with a pump suction speed regulator to make the packing operation
easier. When the machine is activated by rotating the Handles (1) to the START position, the speed is
automatically set to "turbo" or the highest that can be used in normal packing operations. However, when
packing fragile foods in MAGIC VAC
speed, thus allowing control over the performance of the operation by manual activating the sealing
process with the "seal" button (2h) at the proper time.
If the "slow" speed is selected and the "canister" or "marinating" functions are then activated, the speed
will automatically set itself to "turbo".

USE INSTRUCTIONS

fig. A
® bags, it is best to select the "slow" function which reduces the pump
28
" sealing mode will light up.
".