App, Dconnect Cloud And Software Update; System Requirements; Updating The Software - DAB ESYBOX MAX 60/120M Installations- Und Wartungsanleitungen

NA represents the number of devices that participate in pumping.
NC represents the maximum number of devices that can work at the same time.
If there are NA active devices in a chain and NC simultaneous devices with NC smaller than NA, it means that at the most NC devices will start
at the same time and that these devices will exchange with NA elements. If a device is configured with reserve preference, it will be the last in
the starting order, so for example if I have 3 devices and one of these is configured as reserve, the reserve will be the third element to start,
whereas if I set NA=2 the reserve will not start unless one of the two active ones develops a fault.
See also the explanation of the parameter
8.6.8 - NA: Active devices;
8.6.9 NC: Simultaneous devices;
8.6.10 IC: Configuration of the reserve.

12. APP, DCONNECT CLOUD AND SOFTWARE UPDATE

The "Smart Solution" APP DConnect
Via the DConnect APP you can update the product and configure the main parameters of the device with the convenience of an easy-to-use
and always handy APP.
The DConnect APP allows you to get the best out of the product: it is also possible to speed up the creation of your system through the DSync
solution (see dedicated section) and make the necessary updates (see dedicated section) directly from your smartphone without cumbersome
external objects.
Via the APP it is possible to interact locally with the product through the "Direct Connection" menu accessible directly
from the main page of the APP.
The DConnect CLOUD "Smart Solution" allows you to control your systems remotely both through the appropriate
internet portal: dconnect.dabpumps.com
installations", accessible directly from the APP main page.
NOTE 1: The DConnect Cloud remote control service requires registration with the portal and, after a trial period, it requires a subscription. All
information is available on the site:
NOTE 2: This manual refers to DConnect APP menus, colours or descriptions may change.
To get the best out of the product and its interaction with the APP and the DConnect Cloud service, consult also the online documentation and
watch the demonstration videos. All the necessary information is available on the site:

12.1 System requirements

APP requirements: Smartphone
•
- Android ≥ 6 (API level 23).
- IOS ≥ 12
- Internet access, WiFi and Bluetooth enabled.
- Grant the authorisations proposed from time to time by the smartphone operating system
Requirements for access from WebAPP: PC
•
- WEB browser that supports JavaScript (e.g. Microsoft Edge, Firefox, Google Chrome, Safari).
- Internet access.
Note: Microsoft© has announced that Internet Explorer 10 will only be supported until January 2020. For this reason the webAPP does not
support Internet Explorer. However, its replacement, Microsoft Edge, is already available pre-installed in the PC.
Product Network Requirements
•
- Active and permanent direct Internet connection at the installation site.
- WiFi Modem/Router (2.4 Ghz).
- Good quality WiFi signal and power in the area where the product is installed
NOTE: If the WiFi signal is deteriorated, we suggest using a Wifi Extender.
The use of DHCP is recommended, although a Static IP can be set.

12.2 Updating the software

Updates ensure a better use of the services offered by the product.
Before starting to use the product, make sure that it is updated to the latest software version available. During the software update the products
involved cannot carry out pumping functions. For this reason a manned update is recommended.
is, together with the pump display, the interface for local control of the Esybox Max pump.
and through the DConnect APP itself via the appropriate menu "Your
www.internetofpumps.com
ENGLISH
www.internetofpumps.com
64
Menu - Direct connection
Menu - Your Installations
or www.dabpumps.com