Setting Up The Appliance; Aligning The Appliance - hanseatic HWD86W114BE Gebrauchsanleitung

2. Remove the transport safety devices and
keep them safe so that you can use them
for another transportation.
(28)
3. Close off the transport safety holes with
the enclosed covers (28).
Installing the transport safety
devices
• Reinsert the transport safety devices (13)
before each transportation Washer-dryer.
For this purpose, follow the steps de-
scribed above in the reverse sequence.
Set-up and connection

Setting up the appliance

The installation site must fulfil the following
requirements:
– The installation site must be frost-proof.
– A water intake and outlet pipe as well as a
mains plug must be located nearby.
– Even after setting up the appliance, the
mains plug must be easily accessible.
– The ground must be secure, even, clean
and dry.
– The appliance must not be positioned di-
rectly on a rug or carpet as it will then not be
adequately ventilated and can overheat.
Where rugs, carpet, parquet or wood-
en floorboards are present, place a sta-
ble wooden plate measuring at least
60 × 60 cm underneath the appliance.
– When positioning on a wooden plate or
base, these must be equipped with in-
dentations for the screw-on feet so that
the appliance does not migrate off it when
spinning.
– For smooth tiled floors, lay a rubber mat
under the screw-on feet.

Aligning the appliance

1. Manually screw or unscrew each foot
until the washing machine is horizontally
aligned.
2. Twist the lock nuts (29) of all screw-on
feet upwards to the underside of the ap-
pliance and tighten the lock nut against
the underside of the appliance.
Page EN-35
(29)