Checking And Cleaning The Filters - hanseatic HWD86W114BE Gebrauchsanleitung

Checking and cleaning the
filters
NOTICE
Risk of damage to property!
Improper handling of the appliance
can lead to water damage or damage
to the appliance.
■ Turn off the water inlet tap after each
use, before cleaning the water inlet
fi lter or before replacing the seal. Oth-
erwise there is a risk of water dam-
age.
■ Close the valve before cleaning the
fi lter or replacing the gaskets.
■ Check and clean fi lters and gaskets
regularly.
■ Replace defect fi lters and gaskets im-
mediately. Never operate the appli-
ance without fi lters and gaskets.
In the water inlet, the appliance contains fil-
ters that prevent foreign particles from pene-
trating the appliance.
Check and clean the filters every 30 wash cy-
cles or if the appliance is not getting enough
water despite the tap being open completely.
1. Switch off the appliance.
2. Take the mains plug out of the socket and
turn off the tap.
3. Unscrew the water inlet hose (12) from
the valve.
(26)
Care and maintenance
4. Pull the filter (26) out of the union nut,
e.g. with tweezers or a pair of pliers.
5. Rinse the filter under fresh water and
clean with a small, soft brush.
6. Re-insert the filter.
7. Screw the water inlet hose (12) onto the
valve again.
8. Unscrew the water inlet hose from the
appliance.
9. Use pliers to remove the filter (27) from
the inlet hose connecting nozzle (10).
10. Rinse the filter under fresh water and
clean with a small, soft brush.
11. Re-insert the filter and screw the water
inlet hose back onto the connecting noz-
zles.
12. Open the valve to check whether the
water inlet hose and connections are
sealed.
Page EN-31
(10)
(27)