hanseatic HWD86W114BE Gebrauchsanleitung Seite 85

Fixing with a hose holder
• Put the end of the water outlet hose (11)
over a hose holder (not included in pack-
age contents) and hang it over the edge
of a bath.
You can find a hose holder in a specialist
shop or DIY store.
Fixing to an appliance connecting
nozzle
Have a specialist carry out the process of fix-
ing to an appliance connecting nozzle directly
on the siphon.
An unused appliance connecting noz-
zle contains a washer to prevent water
fl owing out. This washer must be replaced
by a seal ring before connecting the water
outlet hose.
Set-up and connection
Creating a water inlet
NOTICE
Risk of damage!
Improper handling of the appliance
may result in damage.
■ Only use the hose delivered with the
appliance to connect to the water
supply. Never use old hoses.
■ Do not connect the appliance to the
hot water supply.
■ Connect the appliance only to a wa-
ter supply with an inlet water pres-
sure between 0.05 Mpa and 1.0 Mpa
(0.5 to 10.0 bar). For higher water
pressure, a pressure regulator needs
to be installed. Enquire about the wa-
ter pressure with the water authority.
■ Do not use a pipe wrench to screw
down the union nuts on the valve.
This can damage the union nuts.
■ Lay the inlet hose without kinks and
connect it carefully.
For the water supply, you will need a valve
with a 3/4 inch screw connection.
1. Screw the water inlet hose (12) onto the
connecting nozzles by hand (10). To do
so, turn the union nut (30) clockwise.
Page EN-37
(10)
(30)
(12)