Setting Up The Appliance; Aligning The Appliance - hanseatic HWD75T214DE Gebrauchsanleitung

Page EN-34 Care and maintenance
~ 145 cm
~ 145 cm
~ 95 cm
~ 95 cm

Setting up the appliance

– The installation site must be frost-proof.
– A water connection as well as a bath or
sink must be available.
– The mains plug must also be easily acces-
sible once the appliance has been set up.
– The ground must be secure, even, clean
and dry.
– It is not appropriate to have a rug or car-
pet under the appliance, as the appliance
will not be ventilated well enough and can
overheat.
– For use on rugs, carpets, parquet or wood-
en floorboards, place a stable wooden
board (measuring at least 60 × 60 cm) un-
derneath the appliance.
– If it is placed on a wooden plate or base,
the screw-on feet should be fixed so that
the appliance does not dislodge itself when
spinning.
– Lay a smooth tiled floor or rubber mat un-
der the screw-on feet.
~ 95 cm
~ 95 cm
~ 140 cm
~ 140 cm
~ 95 cm
~ 95 cm
~ 150 cm
~ 150 cm

Aligning the appliance

1. Loosen the lock nut (33) of one of the
screw-on feet (12) underneath the appli-
ance.
2. Using your hand, screw the foot (12) in
or out as far as necessary. To adjust the
foot, twist it
– anti-clockwise to unscrew.
– clockwise to screw in.
3. Repeat this for the other screw-on feet
until the appliance is standing completely
horizontally and securely.
4. Twist the lock nuts of all screw-on feet
upwards to the underside of the machine
and tighten the lock nut against the un-
derside of the machine.
(33)
(12)