Cleaning The Lint Trap; Emptying Residual Water - hanseatic HWD86W114BE Gebrauchsanleitung

Page EN-32 Care and maintenance

Cleaning the lint trap

CAUTION!
Risk of scalding!
Improper handling of the appliance
can lead to scalding caused by hot suds.
■ Leave the suds to cool before drain-
ing them.
NOTICE
Risk of damage!
If the emergency/residual water is emp-
tied, a quantity of water will fl ow out.
■ Use an adequately large collection
container.
The lint trap stops threads and other foreign
bodies ending up in the pump with the suds.
Clean the lint trap every 30 wash cycles.
1. Switch off the appliance.
2. Close the valve.
3. Open the shutter of the lint trap (15) with
a flat object.
4. Lock the lint trap in place by turning it an-
ticlockwise.
5. Remove the foreign body and clean the
lint trap thoroughly under running water.
6. Replace the lint trap and turn it clockwise
until it clicks into place.
7. Insert the shutter (15) in such a way that
the opening is pointing upwards and
press it firmly.

Emptying residual water

CAUTION!
Risk of injury!
(15)
Improper handling of the appliance
may result in injury.
■ The appliance is very heavy. Nev-
er carry it alone, but always have at
least two persons to do so.
If the appliance is in a frost-prone room, you
must drain the residual water so that it does
not freeze in the appliance and cause dam-
age.
1. Follow steps 1 to 5 as described in
the chapter "Cleaning the lint trap" on
page EN-32.