Adding Laundry; Cancelling/Modifying A Cycle; Cycle End - hanseatic HWD86W114BE Gebrauchsanleitung

Page EN-20 Washing/drying process

Adding laundry

NOTICE
Risk of damage!
Improper handling of the appliance
can lead to water damage.
■ Never open the appliance door when
the water level is high.
■ Never open the appliance door with
force.
You can interrupt the cycle during a wash cy-
cle and add laundry.
1. Press the button (4) for three seconds
to pause the current cycle and add laun-
dry.
2. The cycle will pause, and the display will
show the signal .
3. Depending on the cycle's progress, the
appliance door will either be released with
a click or remain locked:
– If the appliance door is released, the sig-
nal will go out.
– The appliance door will remain closed if
the water level is too high. The appliance
will pump the suds out so that the appli-
ance door can be released.
4. Open the appliance door, add laundry and
then close the appliance door.
5. Press the button (4) in order to contin-
ue the cycle.
You can add laundry only if the water
temperature and the water level per-
mit this (indicated by signal
that a long pause can affect the wash result,
since the suds cool down.

Cancelling/modifying a cycle

Waschen & Trocknen
Waschen & Trocknen 60'
Baumwolle
Mix
Synthetik
Waschen & Trocknen n n
Trocknen
Auffrischen
1. Press the
fy an active cycle.
The washer-dryer will switch off.
2. Press the
switch the washer-dryer back on.
3. Use the cycle selector (1) to select any
cycle and then add detergent if required.
4. Start the new cycle with the
suds away after cycle, see "Draining" on
page EN-22.

Cycle end

The appliance stops automatically as soon as
the selected cycle is finished.
You will hear seven signal tones and the dis-
play (5) will show
When the locking time ends, the signal
go out.
The appliance door will be released with a
click and you can remove the laundry.
1. Leave the appliance door open between
). Please note
cycles and pull the dispensing drawer (6)
out slightly to allow the inside of the appli-
ance to dry.
If no further settings are made, the ap-
pliance will automatically switch off after
15 minutes.
2. Press the
appliance.
3. Turn off the valve and take the mains plug
out of the socket.
(1)
Individuell vi id d
Express 15'
20 °C
Startzeit-
Wolle
Vorwahl
Feines
Temperatur
Intensiv
ECO 40–60
Schleudern
Spülen & Schleudern
Schleudern
button (3) to cancel or modi-
button (3) again in order to
The suds will not be pumped away
after some cycle changes. To pump the
.
End
button (3) to switch off the
(3)
Trockengrad
Ein/Aus
Funktionen
Auswahl
Start/Pause
Nachlegen
button (4).
will