hanseatic HWD86W114BE Gebrauchsanleitung Seite 91

Error code Possible causes
The appliance door is not properly
E30
closed.
Problem with the water inlet:
E10
Valve is closed.
Inlet hose is kinked.
Inlet hose is clogged.
Filter on inlet is clogged.
The water does not drain away.
E21
Too much water in the appliance.
E12
possible causes
EXX
Troubleshooting table
Error code
Solutions, tips
Properly close the door. A 'click' must
be heard).
Open valve.
Check inlet hose; dismantle if neces-
sary and re-align.
Clean filter on the inlet hose (see
page EN-31).
Clean filter on inlet (see page EN-31).
Check whether the drainage hose is
clogged or bent.
Check whether the lint trap is clogged
(see page EN-32).
Pump out the water (see page EN-22)
Switch the appliance off after the
water has been pumped out and
pull out the plug. Close the tap and
contact the service department (see
page EN-44).
Contact the service department (see
page EN-44)
Page EN-43