Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Page EN-24
Installation and connection
Installation and connection
Transport
CAUTION
Risk of injury!
Improper handling of the appliance
may result in injury.
■ The appliance is very heavy. Never
transport or carry it alone, rather al-
ways with at least two persons.
NOTICE
Risk of damage to property!
Improper handling of the appliance
may result in damage.
■ If a trolley is used to move the appli-
ance, the appliance must be lifted as
shown on the packaging. If the appli-
ance cannot be transported upright,
ensure that it is not tilted more than
30°.
■ Exercise caution when moving the ap-
pliance. Do not lift or pull the appli-
ance by any of its protruding parts.
The dryer door must not be used as a
carrying handle.
■ Note that the appliance must not be
installed behind a lockable door, a
sliding door or a door with a hinge on
the opposite side to that of the tum-
ble dryer, in such a way that a full
opening of the tumble dryer door is
restricted.
•
Check whether the paths of transport and
the installation location are suitable for the
weight of the appliance . If in doubt, ask
your landlord or property management .
Setting up the appliance
•
Install the appliance in a frost-proof loca-
tion .
Ideally, the appliance should be installed
next to your washing machine .
•
Install the appliance in a place where
there is a siphon or a sink for connecting
the drain hose .
•
Set up the appliance so that the mains
plug is easily accessible even after the
appliance has been set up .
•
Set up the appliance on a firm, flat, clean,
and dry surface . Do not set up the ap-
pliance on sloping, flexible and uneven
ground .
•
Position the appliance so that air can cir-
culate freely in its immediate vicinity .
•
Position the appliance so that the venti-
lation grilles at the front and rear of the
appliance are unobstructed .
•
Do not remove the feet .
•
The dryer should not be placed on a car-
pet or carpeted flooring, otherwise the ap-
pliance may overheat due to insufficient
ventilation . The floor clearance must not
be restricted by objects such as carpets
and wood strips .
Aligning the appliance
1 . Use a spirit level to check whether the ap-
pliance is level .
2 . To level the appliance, use your hand or a
spanner to turn the levelling feet inwards
or outwards .
To screw the levelling foot outwards, turn
it anticlockwise;
To screw the levelling foot inwards, turn
it clockwise .
3 . Repeat this for the other levelling feet until
the appliance is level and stable .
Werbung
Inhaltsverzeichnis
Fehlerbehebung
