Troubleshooting Table - hanseatic HWD86W114BE Gebrauchsanleitung

Page EN-40

Troubleshooting table

Troubleshooting table
Malfunctions can occur in all electrical appliances. This does not necessarily mean there is a
defect in the appliance. For this reason, check the tables to see if you can correct the malfunction.
WARNING!
Risk of electric shock!
■ Never try to repair an appliance which is defective or presumed to be defective. You
can put your own and future users' lives in danger. Only authorised specialists are
allowed to carry out this repair work.
Problem
Wash result is unsat-
isfactory/poor.
Too much foam is
created during the
wash cycle.
Fabric softener/fab-
ric-care product was
not dispensed.
Laundry is dis-
coloured.
Wash result is not satisfactory
Possible causes
The water is too hard or there is
not enough detergent.
Too much laundry is in the drum. Only load the drum with the maxi-
Selected cycle is not right for the
level of dirtiness of the laundry.
Water temperature is too low.
Stains have not been pre-treated. Treat stains with ox-gall soap or
Too much detergent was used.
The detergent is not suitable for
washer-dryers.
Insert in fabric softener/starch
compartment was not inserted
properly or is clogged.
Laundry was washed at a tem-
perature that was too hot.
Coloured laundry items were
added to the wash.
Solutions, tips
Use the amount of detergent rec-
ommended by the manufacturer
for the water hardness in your
area.
mum amount of laundry intended.
Select another wash cycle or
adjust the level of soiling (see
page EN-20 and page EN-15).
Wash laundry at a higher wa-
ter temperature, select another
wash cycle or increase the water
temperature (see page EN-20 and
page EN-15).
stain remover if necessary.
Next time, use less detergent.
Use detergent suitable for washer-
dryers.
Remove insert and install it again
properly; clean if necessary (see
page EN-30).
Bleach laundry carefully if neces-
sary.
Sort laundry before washing (see
page EN-25).