hanseatic HWD86W114BE Gebrauchsanleitung Seite 89

Problem
Laundry has mould
stains.
Detergent residue on
laundry.
Colours of the laun-
dry have faded.
Problem
Appliance does not
work.
Wash cycle does not
start.
Appliance is not re-
ceiving water.
(error code on
E10
the display)
Water is not being
pumped.
(Error code on
E03
the display)
Wash result is not satisfactory
Possible causes
Damp and/or worn laundry was
kept in the machine.
Too much detergent used.
Detergent contains bleaching
agent.
Stain remover or similar was
used.
Malfunction
Possible causes
Mains plug is not sitting properly
in the socket or is not plugged in.
Socket has no voltage.
Fuse is not intact.
The appliance door is not proper-
ly closed (Error code
E30
display).
Cycle was not started.
Valve is closed.
Inlet hose is kinked.
Inlet hose is clogged.
Filter on inlet is clogged.
Outlet hose is clogged or kinked.
The lint trap is clogged.
Troubleshooting table
Solutions, tips
Remove mould stains carefully
before the next wash, preferably
with a special cleaner. Ask for ad-
vice at a chemist's.
Use the amount of detergent rec-
ommended by the manufacturer
for the water hardness in your
area.
Use colour freshener if necessary
(available at chemist's). In future,
use detergent without bleaching
agent.
Solutions, tips
Plug the mains plug into the
socket properly.
Check fuse; switch on if neces-
sary.
Replace fuse.
Close appliance door properly. (A
in the "click" must be heard.)
Press button (4).
Open valve.
Check inlet hose; dismantle if
necessary and re-align.
Clean filter on the inlet hose (see
page EN-31).
Clean filter on inlet (see
page EN-31).
Check outlet hose; dismantle if
necessary and re-align.
Clean lint trap (see page EN-32).
Page EN-41