hanseatic HWD86W114BE Gebrauchsanleitung Seite 56

Page EN-8 Safety
Risk of injury!
Improper handling of the appliance
may result in injury.
■ The appliance is very heavy. Nev-
er transport or carry the appliance
alone; always with the assistance of
another person.
■ Remove all obstacles on the transport
route and from the installation loca-
tion, e.g. open doors and clear away
objects lying on the fl oor.
■ Do not use the open door as a step,
seat or for support. Make sure that
children and pets do not stand or sit
on the open appliance door.
■ Take care to prevent any risk of trip-
ping when laying out the mains cord
and hoses.
NOTICE
Risk of damage to property!
Improper handling of the appliance
may result in damage.
■ If a trolley is used to move the ap-
pliance, the appliance must be lifted
as shown on the packaging. Always
transport the appliance vertically.
■ Do not use any sharp or pointed ob-
jects when unpacking the appliance.
■ Do not use the appliance door or the
dispensing drawer to pull or lift the
appliance.
■ Remove all packaging material be-
fore fi rst use.
Make sure the appliance is not con-
nected to the power supply whilst the
transport safety devices are being re-
moved or installed.
■ Do not stand the appliance on rugs or
carpets. Otherwise, it may not be able
to properly ventilate, which can result
in overheating and damage.
■ For rugs, carpet, parquet or wooden
fl oorboards, place a stable wooden
plate measuring at least 60 × 60 cm
underneath the appliance.
■ Keep the room well ventilated during
the drying process. Do not allow the
room temperature to exceed 35 °C
during the drying process.
■ Do not place the appliance on top
of other appliances and do not use
it as a base for other appliances (e.g.
for washing machines). Do not sit or
stand on the appliance.
■ Never turn off the appliance before
the end of a drying cycle, unless you
are able to quickly remove all laundry
items and spread them out to dissi-
pate the heat.
Improper handling of the appliance
can lead to water damage.
■ Do not leave the appliance unsuper-
vised for long periods of time while
the valve is open. When draining
as a result of leakiness, substantial
amounts of water may leak out.
■ Do not connect the appliance to the
hot water supply.
■ Connect the appliance only to a wa-
ter supply with an inlet water pressure
between 0.05 Mpa and 1.0 Mpa (0.5
to 10.0 bar). For higher water pres-
sure, a pressure regulator needs to
be installed. Enquire about the water
pressure with the local waterworks.
■ Close the water inlet tap after every
use.
■ Close the water inlet tap before clean-
ing the water inlet fi lter.