Brill Roboline R30 Originalbetriebsanleitung Seite 77

Troubleshooting
Error message
CN002: Lift sensor
CN005: Bumper deflected
CN007: No loop signal
CN008: Loop signal weak
CN010: Bad position
CN011: Escaped robot
CN012: Cal: no loop
CN015: Cal: outside
CN017: Cal: signal weak
454 912_a
Possible cause
Cover has been deflected upwards
by lifting or by a foreign body.
Automatic lawnmower has encoun-
tered an obstacle and cannot free
itself (collision close to base sta-
tion).
No loop signal.
Loop signal weak.
Automatic lawnmower is outside
loop.
Automatic lawnmower has left field. Check routing of loop (curves,
Fault during calibration, automatic
lawnmower could not find loop.
Fault during calibration.
Fault during calibration, loop signal
too weak.
Solution
Remove foreign body.
Check base station power sup-
ply
Check loop
Disconnect and reconnect trans-
former
Check base station power sup-
ply
Check loop, it has possibly been
buried too deep
Disconnect and reconnect trans-
former
Place automatic lawnmower in
mowing area
Loop crossed-over
obstacles, etc.)
Place automatic lawnmower at
right angles to loop, automa-
tic lawnmower must be able to
drive over loop
Check base station power sup-
ply
Check loop
Disconnect and reconnect trans-
former
Place automatic lawnmower at
right angles to loop, automa-
tic lawnmower must be able to
drive over loop
Check base station power sup-
ply
Check loop
Disconnect and reconnect trans-
former
Loop cable crossed-over
Check base station power sup-
ply
Check loop
77