Changing The Pin Code; Setting / Changing The Time - Brill Roboline R30 Originalbetriebsanleitung

en
1. Use the corresponding [arrow keys] (1) or (2) to select the corresponding digits and confi rm each one
with the [multifunction key] (4).
2. Enter the next 3 required digits in the same way.
3. Confi rm the last entry with [multifunction key] (3).
Following this, the LCD display shows the [Change PIN] dialog box.

20.3.4 Changing the PIN code

Change PIN
Enter the new PIN
Abort
1. Enter a new PIN and repeat.
2. Confi rm the last entry with [multifunction key].
After this, the LCD display shows the [Date dialog box].
20.3.5 Setting / changing the date
Enter the date and time correctly, because further programming depends on the date and time.
Enter the date
Confirm
1. Use the corresponding [arrow keys] (1) or (2) to select the corresponding digits and confi rm each one
with the [multifunction key].
After confi rming, the LCD display shows [Time dialog box].
When entering the year (YYYY), it is only necessary to enter the last two digits because the fi rst
ADVICE
two 20XX are preset.

20.3.6 Setting / changing the time

Enter time
24 hour format
Abort Confirm
1. Use the corresponding [arrow keys] to select the corresponding digits and confi rm each one with the
[multifunction key].
Following this, the LCD display shows the [Uncalibrated] status box.
60
4 3
1
2
Press start key
Charge
Betriebsanleitung
Uncalibrated
Roboline™ R30