Sensors - Brill Roboline R30 Originalbetriebsanleitung

en
16.8

Sensors

Security sensor
If the Roboline™ R30 is lifted up by its carry handle during operation, a safety sensor stops the blade within
2 seconds and switches off travel mode.
Rain sensor
The Roboline™ R30 is equipped with a rain sensor that interrupts the mowing procedure in case of rain,
and ensures that the Roboline returns to its base station.
Bump sensors and obstacle detection
The Roboline™ R30 is equipped with sensors that
ensure it changes its direction of travel if it encoun-
ters obstacles. When it encounters an obstacle, the
top part of the housing is shifted slightly. This causes
a sensor to trigger a change in the direction of travel.
Tilt sensor in direction of travel
The Roboline™ R30 is switched off by the tilt sen-
sor if it encounters an upward or downward slope of
more than 35%.
Tilt sensor on side
The Roboline™ R30 is switched off by the tilt sensor
if it encounters sideways slopes of more than 35%.
The Roboline™ R30 does not restart automatically after being switched off by a safety sensor. To
restart, it is necessary to acknowledge the fault by pressing the multifunction key and rectifying
the fault.
50
> 35 %
100 cm
Betriebsanleitung
>35 %
Roboline™ R30