Brill Roboline R30 Originalbetriebsanleitung Seite 61

Startup
20.3.7 Calibration
For calibration, set up the Roboline™ R30 accordingly,
CAUTION!
The drive starts when the [START key] ispressed.
Do not reach into rotating parts.
! Warning !
Drive starts
Charge
1. The automatic calibration procedure starts when the [START key] is pressed.
The [Drive starting] warning flashes on the LCD display.
20.3.8 Calibration procedure starts
Calibration
PHASE [1]
Charge
The Roboline™ R30 first moves straight over the
boundary cable in order to gauge the signal strength,
and then into the base station. The battery of the
Roboline™ R30 is charged.
The Roboline™ R30 must remain stopped
when it moves into the base station.
If the Roboline™ R30 does not meet the
contacts when it moves into the base sta-
tion, it will move further along the boundary
cable until it meets the contacts or the pro-
cedure is cancelled.
20.3.9 Display after the calibration movement
< Program Info >
Total weekly
mowing time xx:xx
Abort Confirm
Following calibration, the [Total weekly mowing time] window is displayed over the program information.
Confirm this display information with the [multifunction key right], then calibration is complete.
The mowing program is active, the battery is charged.
After calibration has been completed, the Roboline™ R30 can be used for mowing with the factory-set
mowing times without further programming.
The following mowing times are factory-set: Mon - Fri: 08:00 - 12:00 and Mon - Fri: 14:00 - 18:00.
454 912_a
see Preparations, page
Commissioning
completed
Mowing program is active
58.
61