Brill Roboline R30 Originalbetriebsanleitung Seite 78

en
Error message
CN018: Cal: Collision
CN038: Battery
CN045: Current sft WL
CN046: Current hrd WL
CN065: Current sft WR
CN066: Current hrd WR
CN099: Recov escape
CN104: Battery over heating
CN107: Battery too cold
CN110: Blade motor over
heating
78
Possible cause
Fault during calibration, collision
Battery flat.
Boundary cable defective, automa-
tic lawnmower does not find base
station.
Battery exhausted.
Charging electronics faulty.
Automatic lawnmower does not
touch charging contacts.
Excess current draw by left drive
motor.
Excess current draw by right drive
motor.
Automatic fault rectification not
possible.
Automatic lawnmower is outside
loop.
Battery overheating - battery tem-
perature above 60 °C, not dischar-
ging possible
Battery too cold < 0 °C.
Overheated mowing motor, tempe-
rature > 80 °C
Betriebsanleitung
Solution
Disconnect and reconnect trans-
former
Remove obstacle
Check base station for obstacles
Check base station charging
contacts
Loop too long, too many islands
Automatic lawnmower has got
stuck
Check boundary cable for interrup-
tions, if necessary have it tested by
an AL-KO service partner.
Battery service life exceeded. Have
battery renewed by an AL-KO ser-
vice partner.
Have charging electronics renewed
by an AL-KO service partner.
Put automatic lawnmower into
base station and check if char-
ging contacts make contact
Have charging contacts che-
cked and renewed by an AL-KO
service partner
Check drive for blockage.
Check drive for blockage.
Rectify fault manually.
Place automatic lawnmower in
base station.
Emergency switch-off by monito-
ring electronic control unit. Do not
place automatic lawnmower on
base station. Switch off automa-
tic lawnmower and let battery cool
down.
Operation not possible.
Switch off automatic lawnmower
and let it cool down. If this reoc-
curs, have automatic lawnmower
checked by an AL-KO service part-
ner.
Roboline™ R30